WireProperties

import type { WireProperties } from "https://googleapis.deno.dev/v1/compute:v1.ts";

The properties of a wire.

interface WireProperties {

bandwidthAllocation?: "ALLOCATE_PER_WIRE" | "SHARED_WITH_WIRE_GROUP";

bandwidthUnmetered?: bigint;

faultResponse?: "DISABLE_PORT" | "NONE";

}

§Properties

bandwidthAllocation?: "ALLOCATE_PER_WIRE" | "SHARED_WITH_WIRE_GROUP"

[src]

The configuration of the bandwidth allocation, one of the following: - ALLOCATE_PER_WIRE: configures a separate unmetered bandwidth allocation (and associated charges) for each wire in the group. - SHARED_WITH_WIRE_GROUP: this is the default behavior, which configures one unmetered bandwidth allocation for the wire group. The unmetered bandwidth is divided equally across each wire in the group, but dynamic throttling reallocates unused unmetered bandwidth from unused or underused wires to other wires in the group.

bandwidthUnmetered?: bigint

[src]

The unmetered bandwidth in Gigabits per second, using decimal units. 10 is 10 Gbps, 100 is 100 Gbps. The bandwidth must be greater than 0.

faultResponse?: "DISABLE_PORT" | "NONE"

[src]

Response when a fault is detected in a pseudowire: - NONE: default. - DISABLE_PORT: set the port line protocol down when inline probes detect a fault. This setting is only permitted on port mode pseudowires.