AttachVolumeInput

import type { AttachVolumeInput } from "https://aws-api.deno.dev/v0.4/services/storagegateway.ts?docs=full";

AttachVolumeInput

interface AttachVolumeInput {

DiskId?: string | null;

GatewayARN: string;

NetworkInterfaceId: string;

TargetName?: string | null;

VolumeARN: string;

}

§Properties

DiskId?: string | null

[src]

The unique device ID or other distinguishing data that identifies the local disk used to create the volume. This value is only required when you are attaching a stored volume.

GatewayARN: string

[src]

The Amazon Resource Name (ARN) of the gateway that you want to attach the volume to.

NetworkInterfaceId: string

[src]

The network interface of the gateway on which to expose the iSCSI target. Only IPv4 addresses are accepted. Use "DescribeGatewayInformation" to get a list of the network interfaces available on a gateway.

Valid Values: A valid IP address.

TargetName?: string | null

[src]

The name of the iSCSI target used by an initiator to connect to a volume and used as a suffix for the target ARN. For example, specifying TargetName as myvolume results in the target ARN of arn:aws:storagegateway:us-east-2:111122223333:gateway/sgw-12A3456B/target/iqn.1997-05.com.amazon:myvolume. The target name must be unique across all volumes on a gateway.

If you don't specify a value, Storage Gateway uses the value that was previously used for this volume as the new target name.

VolumeARN: string

[src]

The Amazon Resource Name (ARN) of the volume to attach to the specified gateway.