Hi there! Are you looking for the official Deno documentation? Try docs.deno.com for all your Deno learning needs.

BufferingHints

import type { BufferingHints } from "https://aws-api.deno.dev/v0.4/services/firehose.ts?docs=full";

Describes hints for the buffering to perform before delivering data to the destination. These options are treated as hints, and therefore Kinesis Data Firehose might choose to use different values when it is optimal. The SizeInMBs and IntervalInSeconds parameters are optional. However, if specify a value for one of them, you must also provide a value for the other.

interface BufferingHints {
IntervalInSeconds?: number | null;
SizeInMBs?: number | null;
}

§Properties

§
IntervalInSeconds?: number | null
[src]

Buffer incoming data for the specified period of time, in seconds, before delivering it to the destination. The default value is 300. This parameter is optional but if you specify a value for it, you must also specify a value for SizeInMBs, and vice versa.

§
SizeInMBs?: number | null
[src]

Buffer incoming data to the specified size, in MiBs, before delivering it to the destination. The default value is 5. This parameter is optional but if you specify a value for it, you must also specify a value for IntervalInSeconds, and vice versa.

We recommend setting this parameter to a value greater than the amount of data you typically ingest into the delivery stream in 10 seconds. For example, if you typically ingest data at 1 MiB/sec, the value should be 10 MiB or higher.